Loopback rijgmethode toegepast op een schoen, zorgt voor een stevig en interessant veterpatroon.

Loopback Threading Method 10

The "Loopback" lacing method is a practical way to lace your shoes securely while creating an interesting pattern. This technique works especially well with elastic laces, which provide a comfortable and adjustable fit. Follow the steps below to apply this method to your shoes.

Step 1

Place the shoe with the toe towards you. Thread the laces from the inside out through the bottom eyelets on both sides, so that the ends of the laces point outwards.

Step 1 of the Loopback lacing method, laces are threaded from the inside out through the bottom eyelets.

Step 2

Take the left side of the lace and pull it in a curl from the inside out through the next eyelet on the same side. This will create a loop on the outside of the shoe.

Step 2 of the Loopback lacing method, the lace is threaded in a curl from the inside to the outside through the next eyelet

Step 3

Continue this pattern by threading the lace in a curl from the inside out until you can go no further. This forms a spiral pattern along the side of the shoe.

Step 3 of the Loopback lacing method, a spiral pattern forms along the side of the shoe.

Step 4

Now take the lace from the other side (right side) and pull it from the inside out through the first hole of the spiral you just created. Then take the lace back and pull it from the inside out through the eyelet on the same side.

Step 4 of the Loopback lacing method, the other lace is threaded from the inside out through the first hole of the spiral.
Step 4 of the Loopback lacing method, the lace is pulled back and threaded through the eyelet again from the inside to the outside

Step 5

Pull the laces tight so that the laces cross in the middle, as shown in the picture. This will ensure a secure fit and a striking pattern in the middle of your shoe.

Step 5 of the Loopback lacing method, laces are pulled tight so that they cross each other in the middle.

Step 6

Then, thread the lace through the last eyelet and secure the ends. If all goes well, the end result should look like the picture. For the final steps, you can tie the laces in the way you want, depending on whether you are using elastic laces. For the closures, you can find the instructions on our instructions page .

Step 6 of the Loopback lacing method, the lace is pulled through the last eyelet and fastened.

Finishing for elastic laces

For elastic laces, use a twist cap to secure the ends. More information about the different types of lace closures can be found on our website.

Zurück zum Blog

Hinterlasse einen Kommentar

Bitte beachte, dass Kommentare vor der Veröffentlichung freigegeben werden müssen.